Nail to make sure that the volume of the machine performance is stable, must need to pay attention to place it in the suitable environment, can effectively maintain the product performance is stable, have the effect of saving resource, from the side to bring us great benefits.
Coil nail manufacturers to remind us that in the process of work, appear any problem should be solve in time, lest appear more serious consequences. Like a roll of nail machine cutting gas leakage problem, the balance should be how to deal with? Need to eliminate the cause of the problem, for example, let's open the cylinder to check the inside of the Iron Nail Making Machine cylinder under the sealing ring is damaged, if is bad, need to change, change after it is ok to try again. If still can't solve, you see whether the gun body wall appeared again, or if there is a foreign body, and whether the sand hole, etc., and if so, it is ok to clean up.
If volume nail machine packing gland leakage, after dismantling the reload also won't because the error of cylinder has a great influence, because manufacturers of coil nail machine pressure are through strict test.
And nail gun oil filter may be too dirty, if it has with three rows of oil filter, because it's too dirty, the cause of its resistance to oil can't according to normal flow into the sealing machine, sealing machine also can because it leads to cooling lubricating oil shortage caused by the rapid warming. If the nail gun near the wall, and was nailed objects too, might affect the cooling, or are there other heat source near the nail gun. When running a nail gun, the front door and door is open, if there is no open, the fan is nail manufacturing machine unable to form a strong airflow. If radiator blockage is the case, there are a lot of dust around like nail gun, for instance, long running can cause nail gun radiator appearance has a lot of dust or oil dirties, and then let its internal copper pipe also is easier to form oil dirties jam, so heat. Without using coil nail machine, must be truncated air source and remove the nails, check the tightness of the screw nail gun before use, cannot be again after nail into the nail on the nail, when loading a nail or operation of this gun, hand or body is placed where the nail may hit. In volume nail machine in use process, if not good for heat dissipation, will affect the normal use, so is because of what factors influence? We can from the volume nail manufacturers have a good understanding.
If you want to adjust the depth of coil nail machine, will first nail gun QiangZui drive up, let the distance to objects further.
Pay attention to slowly adjust depth, if you want to nail the object is different, so the nail gun distance to stare at the distance of the object is different. If the volume and nail the nail machine is not wire nail making machine high, can buy a u-shaped nail gun, then just try U nail, if you have any hexagonal screw nail gun muzzle, also can adjust, because the card pin to remove the nail to, and then into the depth of the adjustment. Note do not use compressed air to power sources, do not use other improper joint, must use the designated nails.