Hydraulic connector is connect different hydraulic components (pump, pipeline, reversing valve, cut-off valve, hydraulic motor, hydraulic cylinder, and a few auxiliary components, such as liquid level gauge, thermometer, pressure gauge, etc.) of the hydraulic system.) Form a closed loop, it is a connecting role in the attachment.Hydraulic joint using rotary joint type single channel to rotating drum, roller, cylinder, etc., oil supply at the end of the cooling water or steam. , and is discharged from the other end. Dual channel tube fixed. Used to rotating cylinder, cylinder or drum with steam, water and oil, and is discharged from the same side. Dual channel tube fixed. This type of dryer difference is there a siphon, condensed 38 needle valve water through the siphon. This type is mainly used for steam. Dual channel tube rotary to the rotating drum, roller, roller and other supplies or discharge water, steam, hot water or hot oil. , inner tube must also rotate together.
Hydraulic coupling this kind of product need to users on the basis of the optimal selection to ensure installation. To make use of the state, the whole system has been achieved and state enough, ensure good performance in ball valve manufacturer the application, which completely meets the requirement. In terms of the installation of the joint, remind you pay attention to clean pipes is very important.
Remind you wash pipe hydraulic joint attention when installation, to ensure that the pipe when the installation is in a state of very clean. Otherwise, if do not pay attention to good cleaning, pipeline internal there will be some dirt and sundries, installed after the joint is not convenient to handle, can cause great pollution to the media, and may lead to other undesirable consequences.
In particular, some requirements of pipeline internal high cleaning systems need to thoroughly clean before installation of each pipe. By this operation, we can ensure the real spoof system is highly clean. Otherwise there will be 14 needle valve internal struggle, oil pollution, the influence system running effect. Because of pollution, will increase damage system parts, shorten the life of system related components.
So in the installation of the hydraulic connector, must pay attention to some key points and pipeline internal inspection, cleaning all parts according to actual situation. Even during the inspection found no obvious dirt, also suggests thoroughly clean all the fitting, to optimize the installation operation, the installation of promoting good effect.